Prusa Mendel Operators Log

When you use the Prusa Mendel, please add notes here. Newest at top.

• Vastly better printing than makerbot. High precision, fast, easy to use, configurable. Extreme objects were tested successfully.

Most minor glitches were on account of provided USB fan. Overhang is best reduced by filleting[1] sharp edges and placing fan a few inches from to printer. However, strong wind may cause unusually tall and thin parts (ie. pencil-like) to print crooked; the fan should be placed at least a foot away in these cases. Fan itself should be externally powered, unplugging it from the laptop USB port disconnects the printer. Unplugging other devices (USB sticks) has no effect. Fan must rest on high-friction (eg. rubber) surface, or will slowly blow itself away. (mirage335, 9-15-2012)

• Found the glass detached from the heater bed, Z-axis badly askew (someone screwed it), and Z-axis end-stop repositioned (someone screwed it too). Performance degraded to worse than the old makerbot, but was repaired after much wasted plastic and lost time. (mirage335, 9-23-20120)