Actions

RepRap Operator's Log

From HacDC Wiki

Revision as of 20:18, 28 November 2010 by Hexagon5un (talk | contribs)

When you use the RepRap, please add notes here. Newest at top.

  • Nov 27, 2010. (Elliot) I finally got up the courage/stupidity to completely remove, disassemble, clean, and re-install the hot end on the reprap extruder. Photos and documentation are at Rebuilding the RepRap Hot End. The short version is that now it's nicely free-flowing and the extrusion speed is limited by the motor (slow!). I also added a 100k thermistor taped to the nozzle (a la makerbot) but I don't know how to re-integrate it into the machine. I also may have left too much of the insulation near the nozzle. If it tears/drags, feel free to trim it.