Actions

Iverilogmakefile

From HacDC Wiki

Revision as of 05:53, 25 October 2009 by Williamgibb (talk | contribs)

This is made for the Digital Design and FPGA workshop run in Fall 2009.

makefile

Assumptions: You have iverilog, vvp and gtkwave in your $PATH. iverilog and vvp are the Icarus Verilog package. gtkwave is the GTKWave+ package.

In order to use this makfile, the TOOL INPUT section must be modified to match your needs. This involves the following

  • Change the SRC macro to include your verilog source code files.
  • Change the TESTBENCH macro to include your verilog testbench.
  • Change the TBOUTPUT macro to the name of the file your dumping your testbench output too.


The posted makefile shows the TOOL INPUT macros pre-populated for targeting an Arithmetic Logic Unit (alu).

###############################################################################
#
# ICARUS VERILOG & GTKWAVE MAKEFILE
# MADE BY WILLIAM GIBB FOR HACDC
# [email protected]
# 
# USE THE FOLLOWING COMMANDS WITH THIS MAKEFILE
#	"make check" - compiles your verilog design - good for checking code
#	"make simulate" - compiles your design+TB & simulates your design
#	"make display" - compiles, simulates and displays waveforms
# 
###############################################################################
#
# CHANGE THESE THREE LINES FOR YOUR DESIGN
#
#TOOL INPUT
SRC = alu.v alu_func.v alu_regn.v dff.v
TESTBENCH = alu_tb.v
TBOUTPUT = waves.lxt	#THIS NEEDS TO MATCH THE OUTPUT FILE
			#FROM YOUR TESTBENCH
###############################################################################
# BE CAREFUL WHEN CHANGING ITEMS BELOW THIS LINE
###############################################################################
#TOOLS
COMPILER = iverilog
SIMULATOR = vvp
VIEWER = gtkwave
#TOOL OPTIONS
COFLAGS = -v -o
SFLAGS = -v
SOUTPUT = -lxt		#SIMULATOR OUTPUT TYPE
#TOOL OUTPUT
COUTPUT = compiler.out			#COMPILER OUTPUT
###############################################################################
#MAKE DIRECTIVES
check : $(TESTBENCH) $(SRC)
	$(COMPILER) -v $(SRC)

simulate: $(COUTPUT)
	$(SIMULATOR) $(SFLAGS) $(COUTPUT) $(SOUTPUT)

display: $(TBOUTPUT)
	$(VIEWER) $(TBOUTPUT) &
#MAKE DEPENDANCIES
$(TBOUTPUT): $(COUTPUT)
	$(SIMULATOR) $(SOPTIONS) $(COUTPUT) $(SOUTPUT)

$(COUTPUT): $(TESTBENCH) $(SRC)
	$(COMPILER) $(COFLAGS) $(COUTPUT) $(TESTBENCH) $(SRC)

convenient file copy script

Convenient file to copy the makefile from ~/resources/makefile to your current directory. copy the script into a file, chmod +x the file and place the file in your $PATH. this assumes that ~/resources/makefile does not have write permissions granted to it.

#!/bin/bash
#
# William Gibb
# Written for HacDC Digital Design and FPGA workshop
#
#variables!
fileofjustice=~/resources/makefile

#script it up!
echo "Copying iVerilog makfile"
if [ -r $fileofjustice ]; then
	cp $fileofjustice .
	chmod u+w ./makefile
	echo "makefile copied"
else
	echo "You don't have the makefile at $fileofjustice"
fi