File:Airflow-switch.stl
From HacDC Wiki
Airflow-switch.stl (file size: 1.12 MB, MIME type: application/acad)
Warning: This file type may contain malicious code. By executing it, your system may be compromised.
Version 2 airflow switch holder for Cheap Chinese Laser. This model was created from the source code here Air flow switch holder. There are still problems with this design. The flap doesn't clear the switch, the flap probably doesn't make enough torque to switch the switch, the axle holes are too small, and the switch mounting screws will run into the attached header.
File history
Click on a date/time to view the file as it appeared at that time.
| Date/Time | Dimensions | User | Comment | |
|---|---|---|---|---|
| current | 04:22, 7 May 2017 | (1.12 MB) | James (talk | contribs) | adjusted filler block between switch and wafer to unblock hinge pin hole |
| 02:01, 7 May 2017 | (1.12 MB) | James (talk | contribs) | changed height of switch screw holes and enlarged flow direction arrow | |
| 23:26, 5 May 2017 | (1.12 MB) | James (talk | contribs) | Version 2 airflow switch holder for Cheap Chinese Laser. This model was created from the source code here Air flow switch holder. Category: CheapChineseLaser |
You cannot overwrite this file.
File usage
The following page uses this file: