Actions

Lulzbot Mini Ninjaflex

From HacDC Wiki

Revision as of 21:07, 12 March 2017 by Ubuntourist (talk | contribs) (With reluctance, added full instructions page)

As of 2017.02.10 the Lulzbot Mini has been repaired and has a brand new extruder head. This extruder head uses NinjaFlex (TM) rubber filament only!

Cura users:

1. Download the newest version of the Lulzbot Edition of Cura from https://www.lulzbot.com/cura 2. Install and start Cura 3. From the menus: Machine -> Add New machine -> Lulzbot Mini 4. From the menus: Machine -> Machine Settings 5. Change Tool Head -> Flexystruder v2 6. E-steps per 1mm filament -> 918 7. OK 8. For your print material, choose NinjaFlex

The recommendation is 220 C for the melting temperature of the material, and it is currently advisable to lay down some glue.

Full Flexystruder head installation and initial setup instructions at https://ohai.lulzbot.com/project/flexystruder-install-lulzbot-mini/accessories/ but unless something goes horribly wrong, you should not need to mess with these instructions.