Actions

Cube Operators Log

From HacDC Wiki

Revision as of 00:01, 9 February 2015 by Nostromo (talk | contribs)

When you use the Cube, please add notes here. Newest at top.

  • James reports: Performed Bed Leveling procedure (Ugh!!). Printing Wilson Piecemeal Y Idler. The print looks a little smooshed on the bottom. Consider recalibrating Z a little higher. --Nostromo (talk) 17:36, 5 February 2015 (PST)
  • James reports: Printed 2nd part on this printer. Reset Z axis to 1.60z so that it wouldn't smoosh the part as much. seemes to have worked but has a little bit of warping of the edges of the 5" part I was printing. Removing the part is requiring long times in a water bath to permeate the glue underneath --Nostromo (talk) 16:01, 8 February 2015 (PST)