Avr2011 Programming The Kit

Hookup:

• your laptop
• an FTDI cable
• the classboard, populated with chip and FTDI header

The chips we use in class are pre-flashed with a bootloader, which means that you can program them over the AVR's serial port.

Plug the FTDI cable into the board -- black wire to GND.

Getting the Board Into Bootloader Mode

When the chip starts up, the bootloader program checks if the "B" button (connected to PD2) is pressed. If the button is pressed, it sits and waits for programming data to come in over the serial line. If the button isn't pressed, it starts your program. So, what you want to do is reset the chip while the "B" button is pressed.

To get the chip into ready-to-program Bootloader Mode:

• Hold down the "B" button
• Tap the "A" button (RESET)
• Now you can release the "B" button

You can tell you're in bootloader mode because your normal code won't be running. If you had and LED on or blinking, for instance, it won't be now.

Programming the Chip

• Get the chip into bootloader mode
• While you're in the directory with your code and the Makefile, type "make" or "sudo make" into the terminal
• Your code will compile, and it will upload your code to the chip
• The chip will automatically reset and start running your program

If all is well, you will see

avrdude: erasing chip
avrdude: reading input file "LED_Demo.hex"
avrdude: input file LED_Demo.hex auto detected as Intel Hex
avrdude: writing flash (156 bytes):

Writing | ################################################## | 100% 0.21s



avrdude: 156 bytes of flash written
avrdude: verifying flash memory against LED_Demo.hex:
avrdude: load data flash data from input file LED_Demo.hex:
avrdude: input file LED_Demo.hex auto detected as Intel Hex
avrdude: input file LED_Demo.hex contains 156 bytes
avrdude: reading on-chip flash data:

Reading | ################################################## | 100% 0.19s



avrdude: verifying ...
avrdude: 156 bytes of flash verified

avrdude: safemode: Fuses OK

avrdude done.  Thank you.

If there are errors...

Common problems and their solutions include:

• Permissions to write to USB port. Solution: keep typing "sudo make" or add yourself to the USB output group:

  Ubuntu: sudo usermod -a -G dialout yourNameHere

• /dev/ttyUSB0 not found. Is the FTDI cable plugged in? Try "lsusb" to see if it's there. Try "ls /dev/ttyUSB*" to see if it's registered as USB1. Edit Makefile accordingly, and remember that you'll probably have to change it back later.