M3D Micro

Andrew Barabasz donated a M3D Micro+ or, more probably an older Micro (2018.05.27).

Included

• M3D Switching Adaptor
  • Output 5.0 V, 4.0 A, (Negative ring, positive tip)

   _____
   -----

• USB 1.0 cable (Type-A male to Type-B male )

Software

• https://support.printm3d.com/892707-M3D-Micro-Downloads
• The "Linux" version is merely a Micro$oft Windoze .NET image that needs mono to run
• Documentation

On Arch Linux, after adding myself to group uucp and installing mono:

   mono ./M3D.App/M3DGUI 1>/dev/null 2>&1 &

installed new firmware, and then wanted to do a 30-minute calibration... Some other time. I'm hungry.