Actions

File

File:Airflow-switch.stl

From HacDC Wiki

Revision as of 06:11, 7 May 2017 by James (talk | contribs) (added v2 problems)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Airflow-switch.stl(file size: 1.12 MB, MIME type: application/acad)

Warning: This file type may contain malicious code. By executing it, your system may be compromised.

Version 2 airflow switch holder for Cheap Chinese Laser. This model was created from the source code here Air flow switch holder. There are still problems with this design. The flap doesn't clear the switch, the flap probably doesn't make enough torque to switch the switch, the axle holes are too small, and the switch mounting screws will run into the attached header.

File history

Click on a date/time to view the file as it appeared at that time.

Date/TimeDimensionsUserComment
current04:22, 7 May 2017 (1.12 MB)James (talk | contribs)adjusted filler block between switch and wafer to unblock hinge pin hole
02:01, 7 May 2017 (1.12 MB)James (talk | contribs)changed height of switch screw holes and enlarged flow direction arrow
23:26, 5 May 2017 (1.12 MB)James (talk | contribs)Version 2 airflow switch holder for Cheap Chinese Laser. This model was created from the source code here Air flow switch holder. Category: CheapChineseLaser

The following page uses this file: