M3D Micro: Difference between revisions
From HacDC Wiki
Ubuntourist (talk | contribs) (WIP) |
Ubuntourist (talk | contribs) (WIP) |
||
| Line 8: | Line 8: | ||
* M3D Switching Adaptor | * M3D Switching Adaptor | ||
** Output 5.0 V, 4.0 A | ** Output 5.0 V, 4.0 A, [[File:Positive_Tip_Plug.svg]] (Negative ring, positive tip) | ||
_____ | _____ | ||
----- | ----- | ||
Revision as of 02:01, 29 May 2018
Andrew Barabasz donated a M3D Micro+ or, more probably an older Micro (2018.05.27).
Included
- M3D Switching Adaptor
- Output 5.0 V, 4.0 A,
(Negative ring, positive tip)
- Output 5.0 V, 4.0 A,
_____ -----
- USB 1.0 cable (Type-A male
to Type-B male 
)
Software
- https://support.printm3d.com/892707-M3D-Micro-Downloads
- The "Linux" version is merely a Micro$oft Windoze .NET image that needs mono to run
- Documentation
On Arch Linux, after adding myself to group uucp and installing mono:
mono ./M3D.App/M3DGUI 1>/dev/null 2>&1 &
installed new firmware, and then wanted to do a 30-minute calibration... Some other time. I'm hungry.