Stereoscan Operators Log: Difference between revisions

Revision as of 06:02, 2 April 2014

While repairing, maintaining, or using the Stereoscan S200 SEM, please add notes here. Newest at top.

- Replace the oil
- Inspect and clean the inlet-filter
- Clean or replace the gas-ballast filters
- Clean the motor fan-cover
- Test the motor condition

Refer to pg. 38 of the user instruction manual

Plasma (talk) 23:02, 1 April 2014 (PDT)

Use ~~~~ to automatically sign edits with username, date, and time. Mirage335 (talk) 08:21, 1 April 2014 (PDT)

March 31st: Cleaned the plinth and took photographs of the vacuum components. Available here. -Dan K.

~~Oil diffusion~~Turbo molecular pump was hanging due to the lip falling out of the rubber suspension. Could be cleaned and probably popped back in.

Broken switch on roughing pump was bypassed internally. Plugging in the outlet should activate the pump. (This pump normally runs 24/7 when the machine is operational.)

March 23rd: A space in the workshop has been cleared. Photo: http://i.imgur.com/BDNWL5z.jpg

@@ Line 2: / Line 2: @@
 '''While repairing, maintaining, or using the Stereoscan S200 SEM, please add notes here. Newest at top.'''
+* The following steps need to be performed on the Edwards roughing pump:
+** Replace the oil
+** Inspect and clean the inlet-filter
+** Clean or replace the gas-ballast filters
+** Clean the motor fan-cover
+** Test the motor condition
+Refer to pg. 38 of the user instruction manual
+[[User:Plasma|Plasma]] ([[User talk:Plasma|talk]]) 23:02, 1 April 2014 (PDT)
 * Use <nowiki>~~~~</nowiki> to automatically sign edits with username, date, and time. [[User:Mirage335|Mirage335]] ([[User talk:Mirage335|talk]]) 08:21, 1 April 2014 (PDT)