DIY ECG notes: Difference between revisions

Latest revision as of 14:51, 4 April 2012

Overview

Here are notes for myself and others interested in building DIY ECG equipment. There are many ways to skin this particular err.. project, from crude to incredibly complex. Here are lists of parts, websites, theory, etc.

Page maintained by User:Obscurite who is working on his own ECG equipment. Enjoy.

PARTS for higher-precision version(s)

Instrumentation Amplifiers (not sure why these are priced so differently)
- Both have CMMR of 110+ for gain of 1000, so they should both work equally well. AD624AD is referenced in the sciam article, but it also mentions the AD620A which is 1/3 the cost at about $7.
- Cheaper version: AD620A
- Expensive version: AD624AD
Better op amp - OP97 (need to review data sheet)

PARTS for basic version(s)

LM358 (dual opamp) or LM324 (quad opamp), or LF353 (which is pin compatible)
Diodes
0.1uF capacitor(s)
Variety of 1/4 watt resistors (10k, 100k, etc)
shielded wires for electrodes (phone or coax cables)
electrodes (soldered pennies, medical electrodes, etc)
diodes (1N4001)

Microcontrollers and FPGAs

Atmel atmega168/328 has onboard ADC
Xilinx Spartan3E dev board has built in ADC

References

These sites, papers, and articles provide info on ECG making, A/D conversion, signal processing, projects, and general theory:

General info:

DIY Projects (some with tutorials):

Kits:

Ramsey ECG kit

@@ Line 53: / Line 53: @@
 Kits:
 * [http://www.ramseyelectronics.com/cgi-bin/commerce.exe?preadd=action&key=ECG1C Ramsey ECG kit]
+[[Category:DIY_ECG]]