Actions

File

Airflow-switch.stl: Difference between revisions

From HacDC Wiki

(James uploaded a new version of "File:Airflow-switch.stl": adjusted filler block between switch and wafer to unblock hinge pin hole)
(added v2 problems)
 
Line 1: Line 1:
Version 2 airflow switch holder for [[Cheap Chinese Laser]].
Version 2 airflow switch holder for [[Cheap Chinese Laser]].
This model was created from the source code here [[Air flow switch holder]].
This model was created from the source code here [[Air flow switch holder]].
There are still problems with this design.  The flap doesn't clear the switch, the flap probably doesn't make enough torque to switch the switch, the axle holes are too small, and the switch mounting screws will run into the attached header.
[[Category: CheapChineseLaser]]
[[Category: CheapChineseLaser]]

Latest revision as of 06:11, 7 May 2017

Version 2 airflow switch holder for Cheap Chinese Laser. This model was created from the source code here Air flow switch holder. There are still problems with this design. The flap doesn't clear the switch, the flap probably doesn't make enough torque to switch the switch, the axle holes are too small, and the switch mounting screws will run into the attached header.

File history

Click on a date/time to view the file as it appeared at that time.

Date/TimeDimensionsUserComment
current04:22, 7 May 2017 (1.12 MB)James (talk | contribs)adjusted filler block between switch and wafer to unblock hinge pin hole
02:01, 7 May 2017 (1.12 MB)James (talk | contribs)changed height of switch screw holes and enlarged flow direction arrow
23:26, 5 May 2017 (1.12 MB)James (talk | contribs)Version 2 airflow switch holder for Cheap Chinese Laser. This model was created from the source code here Air flow switch holder. Category: CheapChineseLaser

The following page uses this file: