Actions

LED Embroidery: Difference between revisions

From HacDC Wiki

No edit summary
No edit summary
 
(One intermediate revision by one other user not shown)
Line 8: Line 8:
* coin cell batteries (3V)
* coin cell batteries (3V)
* <strike>resistors</strike> [http://www.evilmadscientist.com/article.php/throw/print not needed] in this case
* <strike>resistors</strike> [http://www.evilmadscientist.com/article.php/throw/print not needed] in this case
** Limor says lithium coin batteries are internally current-limited
* conductive thread (~25Ohms/foot)
* conductive thread (~25Ohms/foot)
* white 3mm LEDs (3.5V, 20mA)
* white 3mm LEDs (3.5V, 20mA)
Line 34: Line 35:
# Test with battery.
# Test with battery.
# Sew decorative part with regular thread.
# Sew decorative part with regular thread.
[[Category:Proposed_Projects]]

Latest revision as of 15:05, 4 April 2012

At the moment this is Katie's page for planning an LED Embroidery workshop. It may later become a resource page for workshop participants.

LED Calculator

one way to do it

Resources already on hand:

  • coin cell batteries (3V)
  • resistors not needed in this case
    • Limor says lithium coin batteries are internally current-limited
  • conductive thread (~25Ohms/foot)
  • white 3mm LEDs (3.5V, 20mA)

What each participant should get:

  1. embroidery needle
  2. regular embroidery thread
  3. conductive thread
  4. LEDs
  5. embroidery hoop
  6. dark fabric
  7. fabric pencil?
  8. coin cell battery
  9. tape to secure battery?
  10. needle threader

Resource I should provide:

  1. books with constellation drawings
  2. photo and sample of finished piece

Instructions:

  1. Choose a design.
  2. Layout the design with fabric pencil.
  3. Prep LEDs (punch through fabric and twist leads).
  4. Sew circuit with conductive thread.
  5. Test with battery.
  6. Sew decorative part with regular thread.