Cube Alt Slicer: Difference between revisions
From HacDC Wiki
(Created page with "===Experimental=== You can use a regular slicer and convert it to .cube code See this [https://groups.google.com/forum/#!topic/kisslicer-refugee-camp/ZMuIrtn5Mfo Thread] Here...") |
No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
=== | [[Category:Cube]] | ||
=Alternate Slicer Instruction (Experimental)= | |||
'''Don't do this until we verify''' | |||
# Open the Kisslicer link on the desktop | |||
# Load your stl | |||
# Slice | |||
# Save (should save with a .bfb ext) | |||
# Open CodeX32 link on the desktop | |||
## Printer: CubePro | |||
## Function: EnCode | |||
## Input File: your.brb | |||
## Output File: youre.cube (cubepro file should work with cube ext) | |||
==References== | |||
You can use a regular slicer and convert it to .cube code | You can use a regular slicer and convert it to .cube code | ||
See this [https://groups.google.com/forum/#!topic/kisslicer-refugee-camp/ZMuIrtn5Mfo Thread] | See this [https://groups.google.com/forum/#!topic/kisslicer-refugee-camp/ZMuIrtn5Mfo Thread] | ||
| Line 6: | Line 20: | ||
Another [http://cube3d.createaforum.com/general-discussion/alternative-slicer-to-the-cubes-standard-software/ Thread]. This seems to be the latest. | Another [http://cube3d.createaforum.com/general-discussion/alternative-slicer-to-the-cubes-standard-software/ Thread]. This seems to be the latest. | ||
==Troubleshooting Notes== | |||
* Decoding a .cube file generated by cubes software and re-encoding with cubepro setting and then renaming file .cube seems to work. Using cubex setting does not work. | |||
* Setting Filament parameter to -1 does not cause an error | |||
* Setting Time to 0 does not cause an error | |||
Latest revision as of 02:00, 21 April 2015
Alternate Slicer Instruction (Experimental)
Don't do this until we verify
- Open the Kisslicer link on the desktop
- Load your stl
- Slice
- Save (should save with a .bfb ext)
- Open CodeX32 link on the desktop
- Printer: CubePro
- Function: EnCode
- Input File: your.brb
- Output File: youre.cube (cubepro file should work with cube ext)
References
You can use a regular slicer and convert it to .cube code See this Thread
Here's a Thread specific to the cube 2
Another Thread. This seems to be the latest.
Troubleshooting Notes
- Decoding a .cube file generated by cubes software and re-encoding with cubepro setting and then renaming file .cube seems to work. Using cubex setting does not work.
- Setting Filament parameter to -1 does not cause an error
- Setting Time to 0 does not cause an error