RepRap Operator's Log: Difference between revisions

Latest revision as of 15:46, 4 April 2012

When you use the RepRap, please add notes here. Newest at top.

Dec 20, 2010. (Elliot) A while ago, printed out a brutstruder head for the reprap. Assembled, installed, and tested it out last night, and it's a winner. Bought a new gearmotor to replace the old one which was slow and spineless. The thermistor is installed, but I haven't tweaked the relevant settings in the firmware, and not sure that I know how, so the hot end appears to be still running open-loop. This is no good.

Nov 27, 2010. (Elliot) I finally got up the courage/stupidity to completely remove, disassemble, clean, and re-install the hot end on the reprap extruder. Photos and documentation are at Rebuilding the RepRap Hot End. The short version is that now it's nicely free-flowing and the extrusion speed is limited by the motor (slow!). I also added a 100k thermistor taped to the nozzle (a la makerbot) but I don't know how to re-integrate it into the machine. I also may have left too much of the insulation near the nozzle. If it tears/drags, feel free to trim it.

Revision as of 22:56, 21 December 2010 (view source) Hexagon5un (talk \| contribs) No edit summary ← Older edit		Latest revision as of 15:46, 4 April 2012 (view source) Tslagle (talk \| contribs) No edit summary
(One intermediate revision by one other user not shown)
Line 4:		Line 4:

	* Nov 27, 2010. (Elliot) I finally got up the courage/stupidity to completely remove, disassemble, clean, and re-install the hot end on the reprap extruder. Photos and documentation are at [[Rebuilding the RepRap Hot End]]. The short version is that now it's nicely free-flowing and the extrusion speed is limited by the motor (slow!). I also added a 100k thermistor taped to the nozzle (a la makerbot) but I don't know how to re-integrate it into the machine. I also may have left too much of the insulation near the nozzle. If it tears/drags, feel free to trim it.		* Nov 27, 2010. (Elliot) I finally got up the courage/stupidity to completely remove, disassemble, clean, and re-install the hot end on the reprap extruder. Photos and documentation are at [[Rebuilding the RepRap Hot End]]. The short version is that now it's nicely free-flowing and the extrusion speed is limited by the motor (slow!). I also added a 100k thermistor taped to the nozzle (a la makerbot) but I don't know how to re-integrate it into the machine. I also may have left too much of the insulation near the nozzle. If it tears/drags, feel free to trim it.

			[[Category:RepRap]]