RepRap Operator's Log: Difference between revisions
From HacDC Wiki
Hexagon5un (talk | contribs) (Created page with "When you use the RepRap, please add notes here. Newest at top. * Nov 27, 2010. (Elliot) I finally got up the courage/stupidity to completely remove, disassemble, clean, and r...") |
No edit summary |
||
| (5 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
When you use the RepRap, please add notes here. Newest at top. | When you use the RepRap, please add notes here. Newest at top. | ||
* Nov 27, 2010. (Elliot) I finally got up the courage/stupidity to completely remove, disassemble, clean, and re-install the hot end on the reprap extruder. Photos and documentation are at [Rebuilding the RepRap Hot End]. The short version is that now it's nicely free-flowing and the extrusion speed is limited by the motor (slow!). I also added a 100k thermistor taped to the nozzle (a la makerbot) but I don't know how to re-integrate it into the machine. I also may have left too much of the insulation near the nozzle. If it tears/drags, feel free to trim it. | * Dec 20, 2010. (Elliot) A while ago, printed out a brutstruder head for the reprap. [[Image:reprap_brutstruder.jpg|100px]] Assembled, installed, and tested it out last night, and it's a winner. Bought a new gearmotor to replace the old one which was slow and spineless. The thermistor is installed, but I haven't tweaked the relevant settings in the firmware, and not sure that I know how, so the hot end appears to be still running open-loop. This is no good. | ||
* Nov 27, 2010. (Elliot) I finally got up the courage/stupidity to completely remove, disassemble, clean, and re-install the hot end on the reprap extruder. Photos and documentation are at [[Rebuilding the RepRap Hot End]]. The short version is that now it's nicely free-flowing and the extrusion speed is limited by the motor (slow!). I also added a 100k thermistor taped to the nozzle (a la makerbot) but I don't know how to re-integrate it into the machine. I also may have left too much of the insulation near the nozzle. If it tears/drags, feel free to trim it. | |||
[[Category:RepRap]] | |||
Latest revision as of 15:46, 4 April 2012
When you use the RepRap, please add notes here. Newest at top.
- Dec 20, 2010. (Elliot) A while ago, printed out a brutstruder head for the reprap.
Assembled, installed, and tested it out last night, and it's a winner. Bought a new gearmotor to replace the old one which was slow and spineless. The thermistor is installed, but I haven't tweaked the relevant settings in the firmware, and not sure that I know how, so the hot end appears to be still running open-loop. This is no good.
- Nov 27, 2010. (Elliot) I finally got up the courage/stupidity to completely remove, disassemble, clean, and re-install the hot end on the reprap extruder. Photos and documentation are at Rebuilding the RepRap Hot End. The short version is that now it's nicely free-flowing and the extrusion speed is limited by the motor (slow!). I also added a 100k thermistor taped to the nozzle (a la makerbot) but I don't know how to re-integrate it into the machine. I also may have left too much of the insulation near the nozzle. If it tears/drags, feel free to trim it.