Makerbot Operators Log: Difference between revisions
From HacDC Wiki
Hexagon5un (talk | contribs) |
Hexagon5un (talk | contribs) |
||
| Line 3: | Line 3: | ||
* Nov 20, 2010. (Elliot and Tommy) Noticed that gear motor was out of line. Tommy and I added a bearing to it. Extruder still just randomly stops extruding after 15 minutes or so. | * Nov 20, 2010. (Elliot and Tommy) Noticed that gear motor was out of line. Tommy and I added a bearing to it. Extruder still just randomly stops extruding after 15 minutes or so. | ||
* Nov 18, 2010. (Elliot) Printed out some widgets. Extruder head stopped extruding halfway through a print, turned out to be due to ABS bits fouling up the pushing-gear teeth. Also had some troubles with adhesion of the raft to platform. | * Nov 18, 2010. (Elliot) Printed out some widgets. Extruder head stopped extruding halfway through a print, turned out to be due to ABS bits fouling up the pushing-gear teeth. Also had some troubles with adhesion of the raft to platform. | ||
Revision as of 00:03, 21 November 2010
When you use the Cupcake, please add notes here. Newest at top.
- Nov 20, 2010. (Elliot and Tommy) Noticed that gear motor was out of line. Tommy and I added a bearing to it. Extruder still just randomly stops extruding after 15 minutes or so.
- Nov 18, 2010. (Elliot) Printed out some widgets. Extruder head stopped extruding halfway through a print, turned out to be due to ABS bits fouling up the pushing-gear teeth. Also had some troubles with adhesion of the raft to platform.