M3D Micro: Difference between revisions
From HacDC Wiki
Ubuntourist (talk | contribs) (WIP) |
Ubuntourist (talk | contribs) (WIP) |
||
Line 21: | Line 21: | ||
* The "Linux" version is merely a Micro$oft Windoze .NET image that needs mono to run | * The "Linux" version is merely a Micro$oft Windoze .NET image that needs mono to run | ||
* [http://printm3d.com/files/software/linux/README-1.5.0.70.pdf Documentation] | * [http://printm3d.com/files/software/linux/README-1.5.0.70.pdf Documentation] | ||
On Arch Linux, after adding myself to group '''uucp''' and installing '''mono''': | |||
mono ./M3D.App/M3DGUI 1>/dev/null 2>&1 & | |||
installed new firmware, and then wanted to do a 30-minute calibration... Some other time. I'm hungry. |
Revision as of 02:00, 29 May 2018
Andrew Barabasz donated a M3D Micro+ or, more probably an older Micro (2018.05.27).
Included
- M3D Switching Adaptor
- Output 5.0 V, 4.0 A
- Negative ring, positive tip
_____ -----
- USB 1.0 cable (Type-A male to Type-B male )
Software
- https://support.printm3d.com/892707-M3D-Micro-Downloads
- The "Linux" version is merely a Micro$oft Windoze .NET image that needs mono to run
- Documentation
On Arch Linux, after adding myself to group uucp and installing mono:
mono ./M3D.App/M3DGUI 1>/dev/null 2>&1 &
installed new firmware, and then wanted to do a 30-minute calibration... Some other time. I'm hungry.