Airflow-switch.stl: Difference between revisions
From HacDC Wiki
(James uploaded a new version of "File:Airflow-switch.stl": changed height of switch screw holes and enlarged flow direction arrow) |
(added v2 problems) |
||
(One intermediate revision by the same user not shown) | |||
Line 1: | Line 1: | ||
Version 2 airflow switch holder for [[Cheap Chinese Laser]]. | Version 2 airflow switch holder for [[Cheap Chinese Laser]]. | ||
This model was created from the source code here [[Air flow switch holder]]. | This model was created from the source code here [[Air flow switch holder]]. | ||
There are still problems with this design. The flap doesn't clear the switch, the flap probably doesn't make enough torque to switch the switch, the axle holes are too small, and the switch mounting screws will run into the attached header. | |||
[[Category: CheapChineseLaser]] | [[Category: CheapChineseLaser]] |
Latest revision as of 06:11, 7 May 2017
Version 2 airflow switch holder for Cheap Chinese Laser. This model was created from the source code here Air flow switch holder. There are still problems with this design. The flap doesn't clear the switch, the flap probably doesn't make enough torque to switch the switch, the axle holes are too small, and the switch mounting screws will run into the attached header.
File history
Click on a date/time to view the file as it appeared at that time.
Date/Time | Dimensions | User | Comment | |
---|---|---|---|---|
current | 04:22, 7 May 2017 | (1.12 MB) | James (talk | contribs) | adjusted filler block between switch and wafer to unblock hinge pin hole |
02:01, 7 May 2017 | (1.12 MB) | James (talk | contribs) | changed height of switch screw holes and enlarged flow direction arrow | |
23:26, 5 May 2017 | (1.12 MB) | James (talk | contribs) | Version 2 airflow switch holder for Cheap Chinese Laser. This model was created from the source code here Air flow switch holder. Category: CheapChineseLaser |
You cannot overwrite this file.
File usage
The following page uses this file: