Photolithography Supplies: Difference between revisions
From HacDC Wiki
No edit summary |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 5: | Line 5: | ||
These materials work well... | These materials work well... | ||
==Substrate== | ==Substrate== | ||
* [http://www.mouser.com/Tools-Supplies/Prototyping-Products/Copper-Clad-Boards/_/N-b11ou?P=1yzsoajZ1yzvq68 Variety of presensitized copper clad board from mouser.] | * [http://www.mouser.com/Tools-Supplies/Prototyping-Products/Copper-Clad-Boards/_/N-b11ou?P=1yzsoajZ1yzvq68 Variety of presensitized copper clad board from mouser.] [http://www.alliedelec.com/images/products/datasheets/bm/MG_CHEMICALS/70125847.pdf Datasheet.] Specifically recommend 590-660 . | ||
==Developer Chemicals== | ==Developer Chemicals== | ||
Latest revision as of 00:02, 8 April 2014
Premanufactured
These materials work well...
Substrate
- Variety of presensitized copper clad board from mouser. Datasheet. Specifically recommend 590-660 .
Developer Chemicals
Raw
Starting from raw materials may be cheaper and doable, but has yet to be thoroughly tested.
Substrate
- 5 x 8 Scissor Cut Ultra Thin Copper Clad - Cheap for Photolithographic PCB Fab
- 10x 6x8" Photosensitive Dry Film Sheets
Developer Chemicals
Positive developer chemicals apparently use a Sodium Hydroxide and Sodium Silicate mixture. This may reliably permit deep development without overdependent of unexposed regions.
This category currently contains no pages or media.